Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Sliding glass doors
Impact garage doorsPGTCGI
Before
After
Before
After
Before
AfterMr-Glass Roof Replacement & Installation in Riviera Beach: What to Know First
We provide independent Mr-Glass roof replacement and installation in Riviera Beach for homeowners who need the job measured right, quoted on paper, and backed by a written guarantee. Most Mr-Glass roof work in this area runs between $1,800 and $6,500 depending on glass specification, frame condition, and whether the opening needs reframing for current wind-load code. We are not affiliated with Mr-Glass, and we will tell you plainly when a repair makes more sense than a replacement. Call (786) 829-6722 for a free estimate, and a live person will answer.
How Mr-Glass Products Fail - and How We Fix Them
Mr-Glass products installed in Riviera Beach homes face a specific set of conditions: salt air off the inlet, afternoon sun on west-facing openings, and hurricane-cycle wind pressure that tests every seal and flashing point. These are the failure patterns we see most often on Mr-Glass roof units, and how we correct each one.
- Skylight seal delamination on Mr-Glass acrylic dome units. The laminated acrylic layers on older Mr-Glass dome skylights begin separating at the edges after seven to ten years of Riviera Beach sun exposure. The first sign is a milky ring around the perimeter, not a leak. By the time water appears on the ceiling, the inner seal has already failed and the unit is drawing condensation into the chase. We replace the dome with a thermally broken curb-mount unit and re-flash the curb with the existing roof membrane in mind, so the new unit sheds water the way the roof was originally designed to.
- Curved-glass frame corrosion at the lower mullion. Mr-Glass curved roof installations, common on mid-century Riviera Beach ranch homes and lanai conversions, use aluminum mullions that trap salt spray at the bottom channel. We regularly see pitting and white corrosion blooms that eventually flex the glass and crack the seal. The fix is a full mullion replacement with powder-coated aluminum and a weep redesign that lets the channel drain instead of hold water. Skipping the weep redesign just invites the same corrosion back in three years.
- Flashing failure at the curb transition on Mr-Glass flat-roof units. Riviera Beach flat and low-slope roofs move differently than pitched roofs under heat, and Mr-Glass curb-mount skylights are only as watertight as the transition between curb flashing and roof membrane. When a roofer installs the skylight and a glazier does not come behind them, the membrane laps get reversed or sealed with the wrong compound. We re-set the curb, correct the lapping sequence, and use a two-part sealant that holds up to standing water during summer downpours.
- Hail-fractured tempered glass on Mr-Glass roof panels without laminated interlayers. Some Mr-Glass roof installations use tempered-only glass, and a strong Riviera Beach thunderstorm can fracture a panel even when it does not fall out. The glass spiders but holds, and homeowners do not notice until the next rain finds the crack and starts a slow drip. We replace the panel with laminated impact-rated glass when the opening allows for it, and we check the surrounding panels for micro-fractures the same day so you are not back in the same position next storm season.
- Failed thermal breaks on Mr-Glass structural glazing bars. Mr-Glass structural roof systems that use aluminum glazing bars rely on a thermal break, a plastic or polyamide strip between the interior and exterior aluminum. In Riviera Beach heat, that strip degrades over a decade, and the bar begins conducting heat into the room and sweating in humid months. Homeowners notice water beading on the bars, not the glass. The repair is a full bar re-glaze with a new thermal break, which restores the insulating value and stops the condensation. Patching the sealant never fixes this, and we will say so before you spend money on it.
Our Mr-Glass Roof Replacement & Installation Process
We treat every Mr-Glass roof job as a structural opening that happens to hold glass, not a glass job that happens to sit on a roof. The process holds for skylights, sloped glazing, and curb-mount roof units alike.
- 1
Call and site walk. You call (786) 829-6722 and describe what you are seeing. We schedule a time to inspect the unit, measure the opening, and check the roof surface and curb condition around it. No charge for the estimate.
- 2
Measurement and opening check. We measure every opening twice, check the curb for level and square, and note the roof membrane type and slope. If the inspector will need to see wind-load documentation, we pull the current Riviera Beach code requirements before we quote, not after.
- 3
Written quote with OEM and aftermarket lines side by side. We quote Mr-Glass-compatible replacement glass and hardware, and we show you an OEM line and a quality aftermarket line on paper so you see exactly what you are paying for. No phone-call numbers, no allowance ranges you have to trust.
- 4
Removal and prep. We remove the old unit without cutting into the roof membrane more than necessary. We clean the curb, inspect the framing, and repair or replace any rot or corrosion before the new unit goes in. If the roof membrane around the curb needs attention, we tell you before we start, not after the opening is exposed.
- 5
Installation, flashing, and sealing. The new unit is set, flashed in the correct lapping sequence, and sealed with materials rated for Riviera Beach standing water and salt exposure. We register any manufacturer warranty in writing before the truck leaves the driveway, as part of The Keystone Standard.
- 6
Water test and cleanup. We run a hose test on the new installation, check the interior for any sign of moisture, and leave the work area clean. If something is not right, we fix it before we call the job done. If the pane is not true, the job is not done.
What Mr-Glass Roof Replacement & Installation Costs in Riviera Beach
Mr-Glass roof work is priced by the opening, not by the square foot, and several factors move the number. Here is what we see in Riviera Beach as of this year.
- Curb-mount acrylic dome skylight replacement (fixed, non-venting): $1,800 to $2,800 installed, including new flashing and sealant.
- Venting Mr-Glass skylight replacement with manual operator: $2,400 to $3,600 installed, depending on size and whether the operator mechanism is salvageable.
- Curved-glass roof panel replacement (single panel, laminated glass): $2,800 to $4,200 installed, including mullion repair if the existing bar is still sound.
- Full structural glazing bar re-glaze (multiple panels, new thermal breaks): $4,000 to $6,500 installed, depending on panel count and bar length.
- Flashing and curb repair only (unit is sound, the transition is leaking): $600 to $1,400, including membrane correction where needed.
What moves the price is the condition of the curb and roof surface, whether the glass needs to be impact-rated for current code, and whether the opening requires reframing. We quote fixed numbers, not ranges with a change order waiting on the back end. Call (786) 829-6722 for an exact written quote on your Mr-Glass roof unit. Estimates are free.
Why Riviera Beach Homeowners Call TruePane Windows & Doors for Mr-Glass Work
We have been doing glass work in this area since 2008, and we treat a Mr-Glass roof replacement the way we treat every opening we touch: measured twice, quoted on paper, and backed by the Done Right Promise. If it is not done right, we make it right. No paperwork, no arguing. We also work across PGT, CGI, CWS, and ES Windows, so if the right fix on your Riviera Beach home means pairing a new Mr-Glass-compatible panel with hardware from another manufacturer line, we will give you that option and show you the comparison on paper. Dale Kessler grew up in Blue Heron, learned the trade at Palm Beach State College, and has spent the better part of two decades setting glass in Palm Beach County, including getting hurricane-impact specs right the first time so the inspector signs off without a revisit. A live person answers the phone 24 hours a day, 7 days a week.
If it is not right on paper, it will not be right on the wall.
FAQs
Yes, in most cases. If the Mr-Glass unit is still under a transferable warranty, we document the removal and replacement in a way that preserves what remains of the manufacturer coverage, and we register the new unit’s warranty in writing before the truck leaves the driveway. If your roof membrane warranty is the concern, we take care not to cut more of the membrane than the repair requires, and we correct the flashing lapping to the roof manufacturer’s specification. Call (786) 829-6722 and we will tell you exactly what your situation supports.
We quote both, side by side on paper. Some Mr-Glass roof components are still available as OEM parts, and in those cases the OEM line usually makes sense. For older Mr-Glass models where OEM parts are no longer produced or are backordered for months, we specify quality aftermarket replacements that meet or exceed the original glass specification and flashing profile. You decide with the numbers in front of you, not after we have already ordered the part.
Most single-unit replacements, a curb-mount skylight or one curved glass panel, are completed in a single day. Full structural glazing bar re-glazing, where multiple panels and new thermal breaks are involved, typically runs two to three days depending on roof access and weather. We will tell you the schedule before we start, and we hold to it.
If the leak is at the flashing or curb transition and the glass and seal are still sound, repair is usually the right call and runs between $600 and $1,400 in Riviera Beach. If the glass seal has failed, the frame is corroded, or the unit is over 15 years old, replacement is almost always the better long-term investment, and we will show you the cost difference before you commit to either path. Call (786) 829-6722 for an honest read on your unit.
No. We quote fixed numbers, not estimates that stretch. The only time the number changes is if we uncover rot or framing damage that no one could see until the old unit came out, and in that case we stop, show you what we found, and get your written approval before we proceed. No surprise line items on the bill. That is a square deal, and we stand behind it.
Written by Dale Kessler, Owner, TruePane Windows & Doors at TruePane Windows & Doors, serving Riviera Beach and nearby areas.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.