Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Simonton Window Replacement: The Riviera Beach Owner’s Guide
We stock and install Simonton-compatible window replacement parts across Riviera Beach, with most installed prices landing between $185 and $520 depending on the component and series. Our trucks carry the most common balances, pivot bars, sash locks, and weatherstripping for Simonton Reflections, ProFinish, and StormBreaker lines, so most jobs finish in a single visit. Typically, a homeowner calls us after a sash drops, a lock stops catching, or a window that used to glide now needs two hands and a shove.
The salt air off the Lake Worth Lagoon works on hardware faster than people expect. We see it every week: a window that opened fine in October binds by March because the corrosion crept into the balance channel while nobody was looking. If you live east of US-1, count on replacing hardware sooner than the manufacturer’s average lifespan suggests.
Key Takeaways:
- Most Simonton window replacement parts in Riviera Beach run $185-$520 installed
- We stock OEM and proven aftermarket parts on the truck for one-visit service
- Salt corrosion and hurricane-cycle stress shorten part life here by 3-5 years on average
- Both warranty layers registered in writing before we leave your driveway
Which Simonton Models This Applies To
Simonton has produced a long list of series over the years, and the part you need depends entirely on which line is in your house. We work on the Reflections 5050 and 5500, the ProFinish Contractor and Brickmould series, the StormBreaker Plus impact line, and the older Impressions windows still common in homes built around the turn of the century in neighborhoods like Old Port Cove and Lake Park.
Here is the compatibility gotcha most people miss: a balance coil from a Reflections 5050 will not reliably carry the heavier sash on a StormBreaker Plus. The impact-rated units use thicker laminated glass, and that extra weight changes which tension rating the balance needs. Match the wrong one and the window either slams shut or will not stay up. We measure the sash weight and check the stamp codes inside the frame channel before we quote anything.
On the OEM versus aftermarket question: for balances, pivot bars, and tilt latches, a proven aftermarket equivalent from a supplier we trust usually matches or beats Simonton OEM durability at a lower price. For locks and keepers, we prefer OEM because the tolerances matter and a loose lock on an impact window is not a lock, it is a suggestion. We will show you both options side by side on paper and let the price be honest.
Signs Your Simonton Window Replacement Is Failing
- Sash drops or slams when you let go. This is almost always a failed balance coil or tube balance. The tension mechanism has worn out or corroded, and the window cannot hold its position. Left alone, it puts stress on the tilt latches next.
- Window binds, scrapes, or needs two hands to move. In Riviera Beach, we usually find salt corrosion inside the balance channel or a bent pivot bar. The frame itself may still be square, but the hardware is grinding itself down.
- Lock will not catch or pops open on its own. A worn keeper or a misaligned sash creates this. On impact windows, a lock that does not fully engage weakens the seal and fails inspection if you are selling or re-permitting.
- Tilt latches break or the window will not tilt in. Latches on older Simonton windows are plastic and get brittle under Florida sun exposure. Once one side goes, the other follows within a season.
- Draft or moisture at the sill even when closed. Weatherstripping has compressed or torn, or the shoe is not seating. The window is closed, but the outside is still getting invited in.
Replacement Cost & What’s Included
Here is what we charge for the most common Simonton window replacement jobs in Riviera Beach:
- Balance coil or tube balance (single sash): $185-$285 installed
- Pivot bars and pivot shoes (pair): $95-$160 installed
- Sash lock and keeper: $75-$130 installed
- Weatherstripping set (full sash perimeter): $90-$180 installed
- Tilt latch replacement (pair): $65-$110 installed
- Full sash replacement (non-impact glass): $320-$520 installed
The spread comes down to the series, the sash weight, and whether we are pulling parts from the truck or ordering something specific. Every quote is a written line-item price. No surprises on the bill. You get the Done Right Promise on our work, and we register both manufacturer warranty layers in writing before the truck leaves the driveway. If the pane is not true, the job is not done.
DIY or Call Us?
Here is the honest split. You can safely check the stamp codes inside the frame channel, measure the visible sash width, and note whether the window is single-hung or double-hung. That information helps us arrive with the right part on the first visit.
What you should not do is force a binding sash up, pry a stuck tilt latch with a screwdriver, or try to swap a tensioned balance without the right tool. A coiled balance under tension can cut a hand open faster than you can react. If the window is fighting you, stop. Call us at (786) 829-6722. We will be there when we say, with the right part and the right tool, and the job gets done in one visit.
FAQs
Most Simonton hardware lasts 10-15 years in this climate, but salt air exposure east of US-1 can cut that to 7-10 years. We see balances corrode and plastic latches get brittle faster here than inland. If your windows were installed before 2015 and still have original hardware, you are on borrowed time.
Sometimes. We can clean and re-lubricate a binding balance channel or file a keeper back into alignment on some models. But once a coil has lost its tension or a latch has snapped, there is nothing to repair. We will tell you honestly which situation you have, and the call to repair or replace never adds a surprise line item to the bill.
Most single-sash hardware swaps take 30-60 minutes on site. A full sash replacement runs longer because we will set the glass, check the frame for square, and re-weatherstrip the opening. We quote the time upfront, and we do not leave a second appointment hanging.
Our trucks carry the most common Simonton balancers, pivot bars, locks, and weatherstripping. We also keep proven equivalents for Andersen, and Pella on hand for mixed-window houses. If we need something specific, we order it and return once, with the part in hand, at the time we said we would be there. Call (786) 829-6722 for an exact quote, estimates are free.
Written by Dale Kessler, Owner, TruePane Windows & Doors at TruePane Windows & Doors, serving Riviera Beach and nearby areas.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.



Before
After
Before
After
Before
After