Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Sliding glass doors
Impact garage doorsPGTCGI
Before
After
Before
After
Before
AfterTherma-Tru Shingle, Tile & Metal Roofing in Riviera Beach: What to Know First
We provide independent Therma-Tru shingle, tile and metal roofing repair and replacement across Riviera Beach, with most calls diagnosed and resolved in a single visit. As an independent Therma-Tru service provider, we handle the full roofing interface around Therma-Tru entry systems: the flashings, head trims, drip caps, and water-shedding details that keep a door opening dry under Florida rain loads. Pricing runs honest and written, with a free estimate before any work starts. If you own a Therma-Tru door in Riviera Beach and water is getting anywhere near the threshold or the sidelight seams, call (786) 829-6722.
How Therma-Tru Products Fail - and How We Fix Them
- Therma-Tru Classic-Craft and Fiber-Classic door frame corner gaskets. These lines are common in Riviera Beach homes, and the frame corner seals are the first place a roof-driven leak shows up. When water sheeting off a shingle roof hits the entry wall, any gap at the frame corner wicks moisture straight into the subfloor. We see it on doors that were installed without backer rod or with a compressed gasket that never rebounded. The fix is removing the door, re-bedding the frame on a full sill pan, and replacing the corner gaskets before resetting the unit.
- Therma-Tru Slim-Line and Smooth-Star threshold capillary action. The threshold on these lines is a milled aluminum extrusion with weep channels that clog fast in Riviera Beach. Sand, roof grit, and lawn debris work into the channels, and then water running off a tile roof over the entry backs up under the threshold cap. We clean the channels, re-slope the sill where needed, and replace the threshold cap with a slightly taller one that holds off wind-driven rain.
- Therma-Tru sidelight mull post seals on multi-panel entries. When a shingle roof drains across the full width of an entry, the water hits the mull post between door and sidelight at force. Therma-Tru’s mull seals are good but age hard in Florida sun and salt air from the inlet. Once they stiffen, the seal line opens at the bottom. We replace the mull post seal with an OEM or upgraded weather-seal, then re-align the panels so the compression is even the full height.
- Therma-Tru head jamb drip cap undersizing. Builders in Riviera Beach often installed the smallest drip cap that covers the jamb, not the one that sheds water a full 1.25 inches past the brick mold. Over time, water peeling off a metal roof edge gets behind the cap and runs down the wall behind the jamb flashing. We pull the cap, install a properly sized one with the end returns sealed, and the leak stops.
- Improper shingle-to-entry flashing at the king stud. This is the one Therma-Tru’s own documentation cannot fix for you because it happens outside the door assembly. When roofers step-flash a shingle roof against an entry wall and the counter-flashing does not interleave with the door installation flange, water travels behind the flange and shows up inside as a “door leak.” We open the wall plane at the entry, correct the flashing laps, and re-secure the door flange to a clean drainage plane.
Our Therma-Tru Shingle, Tile & Metal Roofing Process
- 1
Call and talk to a person. When you call (786) 829-6722, a live person answers. We listen to what you are seeing, ask about the roof covering above the entry, and schedule the visit.
- 2
On-site inspection. Our technician arrives uniformed and background-checked. We inspect the roof-to-wall transition above the door, the door assembly itself, and the threshold path. We measure everything twice.
- 3
Written diagnosis with part options. We write the issue down, then quote OEM Therma-Tru parts side by side with quality aftermarket where that makes sense for the budget. You get the numbers on paper before any work begins.
- 4
The repair. We remove only what needs removing, set the flashings and seals the way they should have been set originally, and work the details that keep Riviera Beach rain on the outside.
- 5
Water test and walkthrough. We run water where water runs, check the weep path, and walk you through what was done and why.
- 6
Written warranty. Both warranty layers registered in writing, durations stated, before the truck leaves the driveway. If it is not done right, we make it right under the Done Right Promise.
What Therma-Tru Shingle, Tile & Metal Roofing Costs in Riviera Beach
Therma-Tru entry system repairs tied to shingle, tile or metal roofing issues in Riviera Beach typically run from $275 to $1,800 depending on scope. Here are the ranges we quote most often:
- Threshold cap replacement and weep channel cleaning: $275-$525
- Drip cap replacement with proper oversize profile: $390-$650
- Frame corner gasket and sill pan re-bed (door removal and reset): $850-$1,400
- Full flashing correction at king stud with shingle interleave: $1,200-$1,800
Price moves with door height, sidelight count, roof covering type, and how much water damage has already happened behind the wall. Tile and metal roof flashings take longer to interleave correctly than shingle. Call (786) 829-6722 for a free written estimate. No surprises on the bill the day the work is done.
Why Riviera Beach Homeowners Call TruePane Windows & Doors for Therma-Tru Work
We have served Riviera Beach since 2008 through a heritage of craft that Dale Kessler’s father started in finish carpentry and Dale carries forward in the glazing and entry trade. Our technicians know Therma-Tru’s frame geometry well enough to spot a seal issue before the water reaches drywall. When a job calls for a different brand line, we are also an authorized installer for PGT, CGI, CWS, and ES Windows, so we quote what actually fits without pushing a product we do not believe in. A live person answers the phone 24 hours a day, 7 days a week. And the work is covered by the Done Right Promise and The Keystone Standard, both warranty layers registered in writing. If it is not right on paper, it will not be right on the wall.
FAQs
No. As an independent Therma-Tru service provider, our repairs do not void the original manufacturer warranty. We use OEM parts where the warranty path matters and document the work in writing so your warranty file stays clean. Call (786) 829-6722 if you want us to look at a repair another contractor did.
Most threshold cap replacements and weep channel cleanings are done in one visit, usually under two hours. Full frame re-beds with sill pan work can take most of a day. We will tell you the window on the phone before we book it.
Usually not. A frame corner leak is typically a gasket and sill pan failure the first time, and that can be repaired. The door itself often has decades of life left. We only recommend replacement when the frame is rotted through or the door slab is twisted beyond re-alignment.
We keep the common Therma-Tru seals, thresholds, drip caps, and corner gaskets in our Riviera Beach service trucks. Specialty sizes come from our local supplier network, usually within days. No weeks-long waits, and no returning for a second appointment left hanging.
Yes. We correct the wall-to-roof flashing at the entry regardless of who installed the roof. The fix is a flashing interleave done by someone who understands how the door flange and the roof drainage plane relate, which is what our technicians do.
If your Therma-Tru entry is taking water from the roof above it, call (786) 829-6722 for a free estimate. A live person answers, and we will give it to you straight.
Written by Dale Kessler, Owner, TruePane Windows & Doors at TruePane Windows & Doors, serving Riviera Beach and nearby areas.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.